商品描述：
LZ-25商用自流平
产品介绍：
LZ-25商用自流平，采用特种水泥、精细骨料、聚合物喷雾干粉树脂及其它水泥添加剂等原料精制而成，是具有高流动性、高塑性的自流平地基材料，为铺设各类弹性地板、地毯、木地板等地面材料提供平整、完好、坚实的理想基层，属无毒、无害、绿色环保产品。适用于家庭、办公室、小型商业设施等抗压强度要求不高的场所。
PRODUCT DEscriptION
LZ-25 commercial self-leveling compound is combined of special cement, selected aggregate, polymer spray dry powder resin and other cement additives, which is featured as high flowability and high plasticity and environmentally friendly. It can provide smooth, and solid foundation for floor such as elastic floor, carpets and composite floor, etc. And also it has been widely applied in commercial area like office, home and other area.
特点：
快速自动找平地面，快凝，低收缩；
可自由控制施工厚度，施工厚度为3-5mm；
有优良的抗压、抗折强度；
环保、防潮、速干。
CHARACTERISTIC:
Rapid hardening, self-smoothing, and low shrinkage.
The thickness can be controlled freely from 3mm to 5mm.
High compressive and flexural strength.
Environmentally friendly, damp-proof and quick-dry.
基层要求：
①基层须具备室内温度在5-30℃，地面基层的含水率＜千分之三；
②基层必须干燥、坚实、可承重、无妨碍粘结杂物，表面平整；
③具有良好的抗压强度；
④为保证自流平流动性和附着力，建议使用合适的多功能水性界面剂。
REQUIREMENT:
①The indoor allowed temperature should be from 5 to 30 degree Celsius.
②The substrate should be clean, flat, dry and strong without any loose part.
③High compressive strength.
④Suitable primer is highly recommended in order to ensure the self-leveling surface strength and adhesion.
技术参数：
|
LZ-25 |
|
|
存储期 |
6个月 |
|
混合比 |
1:6L/水 |
|
施工面积 |
1.4kg/mm |
|
可施工时间 |
30min |
|
可行人时间 |
3-4h |
|
可铺设地板所需时间 |
3d |
|
抗压强度 |
20-28mpa |
|
抗折强度 |
6 |
TECHNICAL
|
LZ-25 |
|
|
Warranty |
6 months |
|
Mixing rate |
1:6L/水 |
|
Spreading area |
1.4kg/mm |
|
Working time |
30min |
|
Workable time |
3-4h |
|
Floor covering |
3d |
|
Compressive time |
20-28mpa |
|
Flexural strength |
6 |
施工方法：
①基层清理干净后，先选用合适的水性界面剂涂刷基层，当界面剂已被基层吸收，处于全干状态时（施工后1-3小时），开始自流平施工。
②在搅拌容器中加入6L清水，然后慢慢加入一包25kg的自流平，用搅拌机搅拌3-5分钟后，将混合料倒出，均匀地铺开，用专用的齿口刮板控制厚度，混合料必须在20分钟内用完，刚施工好的自流平要防止受阳光直射和强风吹拂。
③在自流平初凝前，用消泡滚筒滚轧地面以排除混合时带入的空气。
ConSTRUCTION STEPS:
①The suitable primer will be roller painted firstly after cleaning up the the basic floor. And the self-leveling compound will be applied after the primer absorbed completely within 1-3 hours.
②The 25kg compound will be mixed slowly by 6L water in container. And poured out the mixer after stirring 3-5minutes by blender mixer. This job should be finished within 20mins by special scraper which can control the thickness around 1-3mm. After done, the finished job should be protected from sun and strong wind.
③ The use of a spiked roller may aid the final leveling of the material and spiked roller should be used within the flow time of the product.
注意事项
由于本品含水泥，会与水反应产生强碱性，避免与皮肤、眼睛接触。一旦接触，立即用水冲洗；如果皮肤或眼睛受到伤害，立即就医。本产品完全硬化后不会产生对身体、环境有影响的物质。
Attention:
The product is considered non-hazardous in normal usage. However it contains Portland cement and reacts alkaline which may cause some skin irritation after prolonged contact. Avoid contact with eyes or skin. In case of contact with eyes, rinse for several minutes under running water, and seek medical advice. Physiologically and ecologically safe when in the cured state.
包装与储存
25kg复合纸袋包装。本品须存放于室内，注意防潮、防止冰冻、曝晒。
托盘上堆放不超过8层，保质期为6个月。
PACKAGE AND STORAGE:
25KG multi-layer paper bag. The warranty is about 6 months. The product shall be stored indoor, protected from moisture, kept away from direct sunlight and source of heat. Stacked on pallets less than 8 layers.
